Electrical Drawing Reading & Build-to-Drawing
309A Construction & Maintenance Electrician · Category: Drawing & wiring · Stamp freshness: 5 years · Standard duration: 30 minutes
Read a residential branch-circuit drawing out loud, then wire exactly that circuit on a practice board and prove it works — the everyday core of residential rough-in work.
The task
You are shown a residential branch-circuit drawing (legend and dimensions included) before the clock starts. Narrate the key reading points, then wire the specified circuit on the practice board: a single-pole switch controlling one light, plus a duplex receptacle on the same branch. Verification is by low-voltage simulation (12/24 V) or de-energized continuity testing — never on mains power.
Performed on a practice board or training panel and recorded in one continuous take with your attempt's dynamic passcode — see the rules centre for the recording rules that apply to every module.
Required steps
- Narrate the reading: identify the supply, switch, light and receptacle symbols and how they connect; state conductor counts and colour conventions.
- Wire the circuit on the practice board to match the drawing, with close-ups of stripped lengths and terminations.
- Verify function: switch controls the light, receptacle shows live indication (low-voltage sim), or narrate point-by-point continuity results.
Safety veto points
Any one of these fails the attempt outright, whatever the total score.
- Energizing (even low-voltage) a circuit that does not match the drawing
- Declaring completion with visibly excessive bare conductor or loose terminations
What the assessor checks
- Wiring matches the drawing exactly
- Switching logic correct
- Function verified successfully on the first attempt
Graded on the five-dimension rubric — Quality 40 · Safety 25 · Craftsmanship 15 · Speed 10 · Preparation 10. Levels: L3 ≥ 90 with Quality ≥ 90 · L2 ≥ 75 · L1 ≥ 60.
What you need
- Practice board with pre-fitted switch, lamp holder and receptacle
- The task drawing (shown on screen, printable A4)
- Conductors, wire strippers, screwdrivers
- Multimeter or continuity tester; low-voltage simulation supply where used
Ready when you are.
Pass the Common Core once, apply for B1, pass its short theory exam, and record your practical. Basic DIY verification is free.
