Modules
Verification modules
Each module is one standardized, recorded practical task, graded against the published standard on its page. Four modules are open now for the 309A electrical trade; two more are in preparation. Basic DIY verification of every open module is free.
Lockout/Tagout & Absence-of-Voltage Verification
The safety gatekeeper module: a complete lockout/tagout and prove-dead sequence on a training panel, performed and narrated in one take.
Electrical Drawing Reading & Build-to-Drawing
Read a residential branch-circuit drawing out loud, then wire exactly that circuit on a practice board and prove it works — the everyday core of residential rough-in work.
1/2″ EMT Bending — 90° Stub-Up with Offset
Bend a 36-inch length of 1/2″ EMT with a 90° stub-up and a 2-inch offset to a dimensioned drawing, fit it to the marked line, and prove every key dimension on camera.
1/2″ EMT Bending — Offset
Bend a clean offset in 1/2″ EMT to clear a stated obstruction depth, fit it to marked lines, and show both landing points on camera.
Energization & Commissioning Checks
Safe energization sequence and pre-commissioning checks on a training setup. Task standards are being finalized — this module is not yet open for application.
Distribution Panel Wiring
Branch-circuit wiring and dressing inside a training distribution panel. Task standards are being finalized — this module is not yet open for application.
