1/2″ EMT Bending — Offset
309A Construction & Maintenance Electrician · Category: Conduit craft · Stamp freshness: 3 years · Standard duration: 30 minutes
Bend a clean offset in 1/2″ EMT to clear a stated obstruction depth, fit it to marked lines, and show both landing points on camera.
The task
Using the offset depth given on the task sheet, mark and bend an offset in 1/2″ EMT, fit it to the marked lines on the practice wall, and demonstrate both end landings and the offset depth with a tape measure on camera.
Performed on a practice board or training panel and recorded in one continuous take with your attempt's dynamic passcode — see the rules centre for the recording rules that apply to every module.
Required steps
- Calculate and mark the two bend points for the stated offset depth.
- Bend the offset, keeping both bends in the same plane.
- Fit to the marked lines and measure the offset depth and end alignment on camera.
Safety veto points
Any one of these fails the attempt outright, whatever the total score.
- Submitting a bend that is flattened or cracked
- Measurement fraud — gauge kept off camera, or readings that do not match the picture
What the assessor checks
- Offset depth and end alignment within ±1/8″
- No dogleg
- No flattening or cracking at the bends
Graded on the five-dimension rubric — Quality 40 · Safety 25 · Craftsmanship 15 · Speed 10 · Preparation 10. Levels: L3 ≥ 90 with Quality ≥ 90 · L2 ≥ 75 · L1 ≥ 60.
What you need
- One length of 1/2″ EMT
- Hand bender for 1/2″ EMT
- Tape measure and level
- Marker; practice wall with marked lines
Ready when you are.
Pass the Common Core once, apply for C2, pass its short theory exam, and record your practical. Basic DIY verification is free.
