Trade Skill Passport
← All modules
C1

1/2″ EMT Bending — 90° Stub-Up with Offset

309A Construction & Maintenance Electrician · Category: Conduit craft · Stamp freshness: 3 years · Standard duration: 30 minutes

Bend a 36-inch length of 1/2″ EMT with a 90° stub-up and a 2-inch offset to a dimensioned drawing, fit it to the marked line, and prove every key dimension on camera.

The task

Using the dimension drawing issued with the task — total length 36″, 90° stub leg 8″ measured from the tube end to the bend apex, offset rise 2″ with the two offset bends spaced for 45° — mark, bend, fit to the marked position on the practice frame, then measure the key dimensions and level on camera, narrating each reading.

Performed on a practice board or training panel and recorded in one continuous take with your attempt's dynamic passcode — see the rules centre for the recording rules that apply to every module.

Required steps

  1. Measure and mark every bend point on camera.
  2. Bend the 90° and the two offset bends with the hand bender.
  3. Fit the conduit to the marked line; measure key dimensions with the tape and check level/plumb, narrating each reading.

Safety veto points

Any one of these fails the attempt outright, whatever the total score.

  • Submitting a bend that is flattened or cracked
  • Measurement fraud — gauge kept off camera, or readings that do not match the picture

What the assessor checks

  • Key dimensions within ±1/8″ (over-tolerance beyond 1/4″ fails the module outright)
  • No visible dogleg
  • No flattening or cracking at the bends

Graded on the five-dimension rubric — Quality 40 · Safety 25 · Craftsmanship 15 · Speed 10 · Preparation 10. Levels: L3 ≥ 90 with Quality ≥ 90 · L2 ≥ 75 · L1 ≥ 60.

What you need

  • One length of 1/2″ EMT, at least 36″
  • Hand bender for 1/2″ EMT
  • Tape measure and level
  • Marker; practice frame or wall with marked lines

Ready when you are.

Pass the Common Core once, apply for C1, pass its short theory exam, and record your practical. Basic DIY verification is free.

Apply for C1Other modules